Skip to content
Here are some before, during & after pics of an axle for a Terex 696 Telehandler, or reach forklift. The front & back sides of the axle have a round boss that we call a trunnion pivot. The copper flanged bushings install over the OD of the round pivot bosses & then the trunnions slide [...]
Here are some pics of a custom copper & brass radiator we built for a 1946 International truck rat rod. The radiator will be cooling a 496 cubic inch big block Chevrolet engine. For airflow we fabricated an aluminum fan shroud & mounted a Spal high performance electric fan. We welcome your inquiries for all [...]
Here are some before & after pics of a smaller bolt-on radiator that we rebuilt for one of our fleet customers. The radiator came in with some leaking damage in the core from the fan blade exploding which flew into the fins & tubes. We completely disassembled the radiator & gave it a rod & [...]
Here’s some before & after pics of a Komatsu 830E haul truck Pivot Eye, or Nosecone, we had in for machining. The bore that houses the spherical bearing was worn & out-of-round. We machined the bore with our RAD (Right Angle Drive) boring fixture for an oversize bearing carrier. After the bore is machined to [...]
Here are some before & after pics of a Caterpillar D10T2 radiator we rebuilt. The radiator is a Modine CGT (Copper Grommeted Tube) type radiator that has individual copper tubes. A good majority of the tubes in this radiator were damaged as well as the fins completely flattened from debris being thrown at it from [...]
Here’s some pics of a Caterpillar 16H Grader we had come in for a complete rebuilding to the circle, drawbar, or table, blade hanger carrier & moldboard, or blade. We removed the complete circle & drawbar assembly from the grader & completely disassembled it. Each part was cleaned, machined, welded & repaired as needed. After [...]
Here are some before & after pics of a bolt-on, or bolt together, radiator that came in for repairing & rebuilding. The radiator is off of a Caterpillar 988 loader. This is a conventional type core radiator with flat or continued fins. The core ended up having several leaks coming from the tubes within the [...]
Here’s some before & after pics of a hardnose cooling system we rebuilt for a Caterpillar D10T2 dozer. This one had some damage to the grill gates as well as substantial external fouling of dirt, mud & debris to the fins of the radiator, ac condenser & aftercoolers. Inside the nosecone, or hardnose, is a [...]
Here’s some pics of a Caterpillar 994H dogbone link that we repaired. The bores on both ends of the dogbone had to be machined, or bored, oversize. We then welded the bores with our automatic bore welding setup fixture. After the welding was done on the bores we then machined the bores back to the [...]
Here’s some pics of a Komatsu 930E-5 MESABI Radiator we rebuilt. Both the LTC (low temp circuit) & HTC (high temp circuit) radiator halves are comprised of all aluminum tubes, or cores. Though we don't prefer nor recommend the aluminum tubes, we recondition each one individually & then buff & polish both ends the same [...]
