Skip to content
Here's a Cat 789B haul truck radiator we overhauled & delivered back to our customer. The 789B radiator is a folded core style unit that had a few sections plugged solid. We did a rod & repair to each individual folded radiator core section before reassembling the radiator & pressure testing it. Motor Mission Machine [...]
This is an old cast iron water pump off of a Continental engine that is in a Clark forklift. The pump came in for repair & rebuilding. We had to machine a new shaft as well as the housing for the new bearings & seals. We got it rebuilt & back together & ready for [...]
This is a Cat 777 triple seven haul truck radiator we have in our stock inventory for exchange. One of our customers is doing an engine change and asked us to deliver it so they will have it on-hand when they are ready to do the engine & radiator swap. It was an awesome snow [...]
This is a custom high efficiency four row radiator we built for a 1940 Ford pickup truck that's powered by a 350 Chevy small block engine. There isn't room for a fan shroud for the 16" high performance electric fan we installed & there's barely enough room for one of our aluminum AC condensers which [...]
This is a set of cylinder heads, connecting rods & the crankshaft for a 292 Y-Block out of a 1955 Ford Thunderbird. We did a three angle valve job & surface to the heads & reconditioned the big ends of the rods with a set of ARP rod bolts. We then balanced the crank & [...]
Here's a couple of 1-5/8" brass coolant diverters we just finished. These diverters are specifically machined for the front coolant ports on early Lincoln 430 CID V8 engine blocks. These are hard to find and obsolete parts that are often found to be disintegrated upon engine disassembly & extremely important for a proper engine rebuild [...]
Here's a couple of Hitachi shovel radiators we picked up along with an aluminum oil cooler for a drill rig for repairing & overhauling. The radiator on the stand is an EX5500 shovel Mesabi style radiator and the radiator laying down on the pallet is an EX5600 radiator. Motor Mission Machine & Radiator5435 Desert Point [...]
This is an older antique water pump & governor that was shipped to us for repairing & rebuilding. It's off of a Cletrac crawler dozer that is being restored for a museum on the east coast. We had to make a new shaft & machine the housing for the new bearings & seals. Motor Mission [...]
Here's a Komatsu 830E mining haul truck radiator we rebuilt and delivered back to our customer. This radiator is a Mesabi style that has over eleven hundred individual tubes. It is made up of two radiators. One being the low temp circuit & the other half being the high temp circuit. Jimmy EwingMotor Mission Machine [...]
This is a 3.8 liter V6 Ford engine we did a short block rebuild to. This particular engine was out of a Mercury Cougar but it is the same engine that was also in the Ford Thunderbird as well as some other Ford models. We performed all the machine work to the block, crank & [...]
