Skip to content
Here's a set of aluminum V8 cylinder heads for a high performance Ford Mustang. They are 4.6 liter Coyote engine cylinder heads. After getting them all cleaned up and checked out we did a three angle valve job to them for some new oversize stainless steel valves. After the valve job was all done we [...]
Here's some pics of some big rig tractor semi truck radiators we're recoring and repairing. Some of them have crankholes in them for the shaft of a PTO to go through. Motor Mission Machine & Radiator 5435 Desert Point Dr. Las Vegas, Nv. 89118 Phone: (702) 649-2366 or (702) 649-0648 Fax: (702) 649-4133 www.MotorMission.com Facebook.com/MotorMission [...]
Here's some pics of a Ford 351 Cleveland V8 engine that came in for a complete rebuild. It's been sitting for several years and appears to have ingested some water inside the engine. We'll get it disassembled, thermal cleaned, shotblasted, magnafluxed and inspected to see what all it needs. Motor Mission Machine & Radiator 5435 [...]
This is a crane radiator we did a rod and repair to. The radiator came in for a standard check up and overhaul to make sure it's ready for another round with a new engine. We got it looking like new and ready for another service interval. Motor Mission Machine & Radiator 5435 Desert Point [...]
Here's some pics of a 4.6 liter Ford Mustang Coyote engine we're machining for a high performance build. In these pics the aluminum block is in our Sunnen line honing machine getting ready to have the housing bore align honed. We have outfitted the main caps with ARP studs and hardware to provide extra strength [...]
Here's some before & after pics of a Cat radiator we recored. It's off of a 966 loader that was running hot. The original core was pretty used up so it was agreed upon to recore the radiator with a new high efficiency core. Motor Mission Machine & Radiator 5435 Desert Point Dr. Las Vegas, [...]
Here's some pics of a 350 Chevy small block engine we're rebuilding. In these pics it is a shortblock assembly. A shortblock consists of the crankshaft, pistons/rods, camshaft, and timing set all installed in the block. Once we get the cylinder heads bolted on it will be a longblock and then it will be onto [...]
Here's some pics of a heavy duty compressor cooler in the middle of our rebuild process. The cooler is off of a Caterpillar MD6240 drill rig. It is a Mesabi style high pressure air-to-oil cooler with round aluminum fins. Motor Mission Machine & Radiator 5435 Desert Point Dr. Las Vegas, Nv. 89118 Phone: (702) 649-2366 [...]
Here's some pics of a Caterpillar 16M grader axle we're rebuilding. In these pics the axle is all machined, painted, and ready for assembly. We have welded all the bores and bored them out to their proper sizes with our portable line boring equipment and tooling. We then pressed all the new bearings, bushings, and [...]
Here's a couple pics of some work we brought in for repairs and rebuilding. On the front of the trailer is a Cat 789B haul truck folded core radiator. Next is some Dozer modular radiator core sections, a wiggle wagon radiator, and a couple of Dozer Charge air coolers (CAC's) and aftercoolers. On the middle [...]
