Skip to content
This is a couple of Berkeley ground water pumps we recently finished rebuilding for one of our mine customers in northern Nevada. One of the pumps was locked up with rocks lodged in its impeller. We completely disassembled both pumps and completely rebuilt them with all new bearings and seals after we performed [...]
Here's a couple of Caterpillar 793C haul truck radiators loaded onto our trailer. The clean and shiny 793C radiator is being delivered after we have rebuilt it. The dirty 793C radiator is being picked up for rebuilding. This is a good showing of what they look like when we pick them up for [...]
We are the premier machine shop in Las Vegas, Nv. for diesel engine machining, connecting rod reconditioning, cylinder head rebuilding, line boring, and surfacing or milling. The first two pictures in this post are of a set of Cummins 8.3 connecting rods that we reconditioned with new wrist pin bushings. The last three [...]
If you need any type of radiator repair or service look no further than our fully equipped Las Vegas Radiator Shop. We have the experience, expertise, and the equipment necessary to perform any and all radiator and heat transfer services right here at our radiator shop located in the Las Vegas, Nv. valley. [...]
Las Vegas machine shop with complete machine shop capabilities is what we offer here at Motor Mission Machine & Radiator. If you need any machine work related here in the Las Vegas valley we are fully equipped with all the machines and experience necessary to perform any and all machine work. If you [...]
Las Vegas radiator repair, rebuilding, and manufacturing is what we do here at our Las Vegas Radiator Shop called Motor Mission Machine & Radiator. If you are in the Las Vegas area and need any radiator repair, radiator rebuilding, radiator rodding, radiator rod and repair, radiator help, or anything radiator related please give [...]
This is a gas tank for a 1972 Chevy C10 pick-up truck that came in for some modifications. The fuel tank is being used with electronic fuel injection (efi) so we had to add a 3/8" fuel feed fitting, a 3/8" fuel return line fitting, as well as some vent fittings. We machined [...]
These are some pictures of a customer's Chevy Corvette with the small block engine in it that we built into a 383 stroker engine. This engine build started with a GM 4-bolt main roller block with a one piece rear main seal. We performed all the machine work to the cylinder block with [...]
This is a copper heat exchanger that came in leaking. We had to cut one of the side plates off of the cooler so we could get to the leaking tube. We ended up cutting out the section of tube that was leaking so we could cut, fab, and fit a new section [...]
This is a 360 Ford FE (Ford Edsel) rotating assembly for an engine we're rebuilding. The 360 Ford is very similar to the 390 FE engine. The only difference is the stroke of the crankshaft, length of the connecting rods, & compression height of the pistons between the two engines. In these pictures [...]
