Skip to content
This is an aluminum hydraulic oil cooler with an aluminum fan shroud and a high performance electric fan we supplied to one of our mining customers. They have a hydraulic system on one of their pieces of equipment that keeps overheating and shutting down so they asked us to set them up with [...]
These are pictures of a cylinder block for a 1964 Lincoln 430 cubic inch V8 engine. In the pictures you can see that the cylinders have been bored for the new oversize pistons and rings which we did on our Rottler boring bar. The cylinders were finish honed to their final size on [...]
Here's a bunch of Caterpillar cores we've been rebuilding and overhauling here at Motor Mission. In the pics are a bunch of Caterpillar part number 2W5540 folded radiator cores. We rebuild a lot of these folded radiator cores with a rod and repair for the 793C haul truck radiators that we rebuild and [...]
This is a cast iron stove handle that was sent into us for some repair. The stove handle had a broken bolt in it so we had to machine out the broken bolt or stud. We then had to machine some new threads into the handle for a complete thread repair service. We [...]
This is a Chrysler Dodge 318 cast iron V8 cylinder block. The block is sitting in our Sunnen CK10 cylinder hone. We just pulled it off of our Rottler boring bar where we bored the cylinders for the new oversize pistons and rings. The block is now getting mounted and setup in the [...]
This is a Caterpillar 740 dump truck radiator, oil cooler, and AC condenser we rebuilt for one of our mining customers in Northern Nevada. This haul truck is a Caterpillar & Volvo machine. Many people refer to this type of machine as a Wiggle Wagon because it is an articulating dump truck. Our [...]
This is a 4.3 liter 265 cubic inch Dodge Chrysler Plymouth inline six cylinder flathead engine that we just finished rebuilding. This engine is out of a hay squeeze which is basically a big forklift. This engine is also very similar to the Continental flathead six cylinder industrial engine that is seen in [...]
This is a plastic and aluminum radiator out of a Caterpillar 336E excavator trackhoe track hoe backhoe radiator that came in for a rod and repair. This radiator is made of an aluminum core with plastic inlet and outlet radiator tanks (end caps). The tubes are leaking at the headers on both ends [...]
This is a 318 cubic inch Dodge Magnum V8 engine cylinder block, crankshaft, & pistons on the connecting rods that came in for machine work. After cleaning, magnafluxing for cracks, measuring, & inspecting the block, crank, & rods, we will proceed with the necessary machining. The machine work we will be doing is [...]
This is a copper and brass heat exchanger we built at a customer's request. It is similar to the old original R&M Specialty Products vehicle mounted hot water element that is no longer available. How it works is you mount the heating element to your vehicle and plumb your vehicle engine coolant to [...]
