Skip to content
Here’s some pics of a gas tank that came in for cleaning & repair due to rotten & varnished gas inside the tank. We eneded up having to cut the tank apart because the fuel pick-up tube was plugged solid. The internal reservoir at the end of the pick-up tube was plastic & housed a [...]
Here’s some pics of a couple of Caterpillar haul truck radiators we're disassembling for cleaning & repair. The stack of sixty folded radiator cores are for a 793C haul truck. The other radiator is a 793F Mesabi with just about all of its seven hundred & sixty eight tubes removed from the tanks & sideframes [...]
Here's some before & after pics of a cast iron diesel exhaust manifold that came in for surfacing. The flanges were not sitting at the same plane to each other which was causing excessive exhaust leaks between the exhaust manifold & the cylinder head. Surfacing the exhaust flanges flat from one end to the other [...]
Here’s some pics of an aluminum radiator & oil cooler that we had come in for repairing & rebuilding. They are both off of an Atlas Copco, or Epiroc, PV271 (Pit Viper) drill rig. We got them both cleaned up inside & out, repaired & pressure tested with no leaks. They are now ready for [...]
Here’s some pics of a Hitachi EX5600 shovel radiator that needed some recoring. All eight cores were in pretty bad shape so we recored both the high temp radiator as well as the low temp radiator with new heavy duty high efficiency cores. After pressure testing each radiator half to ensure they had no leaks [...]
Here’s some pics of a spindle housing we have setup with our automatic bore welder. When we repair & recondition a grader axle each part gets completely repaired & reconditioned back to OE specs. Most of the time the bores where a pin goes are worn & out-of-round. We first machine the bores true & [...]
Here’s some pics of a Caterpillar D10 Dozer Fusion hardnose cooling package we picked up for repairing & rebuilding. The radiator, oil coolers, aftercoolers & other heat exchanger components are all aluminum units. We'll post more pics after we get it rebuilt & ready to go. 5435 Desert Point Dr. Las Vegas, Nv. 89118 Ph: [...]
Here’s some pics of an a-frame that we replaced the yoke in. The a-frame is the rear axle diff housing support for a Caterpillar 793C haul truck. The bore is where the hitch pin goes & the bore & bolt holes around the bore normally come in with several cracks. The center piece where the [...]
Here’s some pics of some radiator projects going on in the radiator shop. The first four pics are of a bolt-on radiator off of a garbage truck. The hole in the core is for the PTO (Power Take-off). The aluminum radiator is off of a Caterpillar D10T Fusion dozer. The three smaller aluminum coolers are [...]
Here’s some pics of a 5.9 Cummins diesel engine block out of a Dodge Ram truck. The engine block is mounted in our Sunnen CK10 cylinder honing machine. On top of the block is a two inch thick torque plate that is torqued to the deck of the block with a set of ARP cylinder [...]
