Skip to content
Here are some International DT350 diesel engine parts that came in for complete machine work. The crankshaft & camshaft were cleaned, wet mag'd for cracks, inspected & polished. The connecting rods were reconditioned on their big ends & new tapered wrist pin bushings installed & machined to size on the small ends. The block was [...]
This is a P&H 2650cx Shovel Radiator we picked up for repairing & rebuilding. This radiator consists of a high temp radiator half & a low temp radiator half. Each circuit is made up of two MB (mechanically bonded) radiator cores for a total of four radiator cores. The fan came apart & punctured some [...]
This is a Caterpillar 793D haul truck radiator we completely rebuilt. This one is an NGMR (next generation modular radiator) which has the Caterpillar square modular cores. Each core, or section, got a rod & repair before being assembled into the complete radiator assembly. After the final pressure test we loaded it on one of [...]
Here's some Trunnion Supports & a Pinion Support we repaired. These parts are off of Loaders & RTD's (Rubber Tire Dozers). The trunnions come in with the bores, flanges & surfaces worn & fretted (pitted). We first machine all the surfaces & machine all the bores so they can be welded back up. We then [...]
This is a delivery & pick-up we made for some Caterpillar haul truck parts. We repaired & overhauled the fuel tank which fits a Caterpillar 793C or 793D haul truck. While on the run to make that delivery we were fortunate enough to pick-up the radiator for rebuilding which is for a Caterpillar 793D haul [...]
This is a 3208 Caterpillar V8 diesel engine out of a V550D Tire Handler. The engine came in all in pieces in a couple of boxes. The cylinders were worn, the deck heights of the block were both below the minimum & the heads were also below the minimum thicknesses. We sourced a replacement block [...]
This is an older antique copper brass radiator out of a 1931 Chevy. The core is an old honeycomb type which are relatively delicate to work with. We removed & reset both the top & bottom tanks. While the tanks were removed we rodded each tube to make sure they're all clean & nice flowing. [...]
This is the Caterpillar 834H hardnose, or nosecone, cooling package we picked up & posted earlier this week. We got all the modular AMOCS radiator cores, oil coolers & air-to-air coolers all cleaned, repaired, rebuilt or replaced & re-installed into the hardnose. The hydraulic fan motor was replaced as well as all the hydraulic hoses. [...]
This is a cylinder block assembly for a Polaris RZR XP 1000 that came in for machining. The surface was warped as well as twisted which caused the head gasket to leak. We mounted the cylinder block assembly to the dual axis leveling table on our Rottler CNC milling machine for the setup. We then [...]
This is the hardnose, or nosecone, cooling package off of a Caterpillar 834H we picked up for a complete repair & rebuild. All the cooling system components will be removed for cleaning, pressure testing, repair & re-pressure testing before final re-assembly of all the components back into the hardnose. Motor Mission Machine & Radiator 5435 [...]
