Skip to content
This is a small block Chevy V8 engine we're finishing up the rebuild to. The engine was disassembled, cleaned, checked & measured. We performed all the machine work to the block, crank, connecting rods & cylinder heads along with balancing of the rotating assembly. The engine is currently in the final stages of assembly. Motor [...]
This is a Komatsu 830E haul truck Mesabi radiator we picked up for rebuilding. All the tubes will get removed to be ultrasonic cleaned & reconditioned before being installed back into the tanks with all new rubber seals. Motor Mission Machine & Radiator 5435 Desert Point Dr. Las Vegas, Nv. 89118 Ph: (702) 649-2366 or [...]
This is a 2007 Chevy 6.6 liter Duramax LBZ diesel engine block getting the housing bore line bored on our Rottler EM105H CNC machine. The block is fitted with a set of Wagler billet main caps held in place with a set of ARP main studs. Motor Mission Machine & Radiator 5435 Desert Point Dr. [...]
Here's some smaller passenger car & truck size radiators we have in for rod & repair & more than likely some recoring. These radiators are damaged, dirty & internally plugged & clogged down in the tubes. The headers look terrible!! We'll get 'em fixed up & looking like new again. Motor Mission Machine & Radiator [...]
This is a Caterpillar 789B haul truck folded core radiator we did a complete overhaul to. We delivered it back to our customer along with a Ford F750 air suspension drivers seat that we repaired & upholstered. The horizon was filled with smoke from all the wildfires that are happening right now. Motor Mission Machine [...]
This is a 6.6 liter Duramax diesel V8 steel crankshaft. The engine developed a knock that kept getting louder. After the engine was disassembled we found the number two main housing bore is a bit damaged so we suspected the crank was cracked. It didn't break but it's close to it. The crank is cracked [...]
Here's a Caterpillar 793C mining haul truck folded core radiator. In the one pic it is in our test tank getting pressure tested. After the pressure test is completed the radiator gets a final cleaning, prepping & touch up on the paint. Motor Mission Machine & Radiator 5435 Desert Point Dr. Las Vegas, Nv. 89118 [...]
This is a Caterpillar trunnion support for an 854G RTD (Rubber Tire Dozer). The mounting pads of the trunnion support were worn & damaged which required welding the worn areas up. Here the trunnion support is mounted on our Rottler EM100 CNC machine getting the surfaces squared & surfaced flat. Motor Mission Machine & Radiator [...]
This is a Caterpillar 777 folded core radiator we rebuilt & exchanged with our customer. This radiator is for a water truck which is used to water the haul roads at the mine which keeps the dust down for safely operating the haul trucks onsite. Motor Mission Machine & Radiator 5435 Desert Point Dr. Las [...]
This is a 1998 Chevy 350 small block engine we did all the machine work to. After the block, cylinder heads & connecting rods were thermal cleaned & blasted they were all magnafluxed for cracks. The rods got their big ends reconditioned while the heads received a three angle valve job & surface. The block [...]
