Skip to content
1940 Ford Truck Custom Built Copper Brass High Efficiency Four Row Radiator Core
This is a custom high efficiency four row radiator we built for a 1940 Ford pickup truck that's powered by a 350 Chevy small block engine. There isn't room for a fan shroud for the [...]
1955 Ford Thunderbird 292 Y Block Crankshaft, Connecting Rods and Cylinder Heads Machining
This is a set of cylinder heads, connecting rods & the crankshaft for a 292 Y-Block out of a 1955 Ford Thunderbird. We did a three angle valve job & surface to the heads & [...]
Custom Machining 430 Lincoln Brass Water Antifreeze Coolant Diverters
Here's a couple of 1-5/8" brass coolant diverters we just finished. These diverters are specifically machined for the front coolant ports on early Lincoln 430 CID V8 engine blocks. These are hard to find and [...]
Hitachi EX5500 and EX5600 Radiators and Drill Rig Oil Cooler
Here's a couple of Hitachi shovel radiators we picked up along with an aluminum oil cooler for a drill rig for repairing & overhauling. The radiator on the stand is an EX5500 shovel Mesabi style [...]
Old Antique Cletrac Crawler Dozer Water Pump and Governor Repair and Rebuild
This is an older antique water pump & governor that was shipped to us for repairing & rebuilding. It's off of a Cletrac crawler dozer that is being restored for a museum on the east [...]
Komatsu Mining 830E Haul Truck Mesabi Radiator Repair and Rebuild
Here's a Komatsu 830E mining haul truck radiator we rebuilt and delivered back to our customer. This radiator is a Mesabi style that has over eleven hundred individual tubes. It is made up of two [...]
Ford Thunderbird Mercury Cougar 3.8 V6 Engine Rebuild
This is a 3.8 liter V6 Ford engine we did a short block rebuild to. This particular engine was out of a Mercury Cougar but it is the same engine that was also in the [...]
Cat 994 Loader Oil Coolers Repair and Reconditioning
This is a set of Cat 994 loader oil coolers we recored with new heavy duty cores. These coolers are made of all steel construction and have a tendency to run a little warm in [...]
6.0 Liter Chevrolet LS Cast Iron V8 Engine Block Cylinder Honing
This is a Chevrolet 6.0 liter LQ9 cast iron block in our Sunnen CK10 cylinder honing machine getting it's cylinders honed. The LQ9 is an LS based engine and is often desired & used for [...]
Cat and Hitachi Mining Equipment Radiator, Coolers, Bellcrank Y-link and Fuel Tank Rebuilding
Here's some pics of a delivery & pick up of some radiators, oil coolers, a fuel tank & a bellcrank Y-link. On the delivery was a couple of Hitachi EX5500 shovel hydraulic oil coolers, a [...]
Hercules G1600 Cast Iron Water Pump Repair and Rebuilding
This is a Hercules G1600 cast iron water pump off of a wood chipper. It came in for a repair & rebuild. The shaft & bearing were shot which caused the fan to hit the [...]
Chevrolet LS1 Aluminum Engine Block Machining
This is a Chevy GM LS1 aluminum engine block in our Sunnen line hone. The mains, or housing bore, took a beating so the main line needed to be trued up and straightened out. We [...]