Skip to content
Here’s some pics of a Caterpillar D10T hardnose, or nosecone we picked up for repair & rebuilding. This cooling package consists of the Caterpillar AMOCS (Advanced Modular Cooling System) type radiator. There are twelve individual cores, or sections, that make up the radiator. Ten long cores & two short cores/sections. We also picked up the [...]
Here’s some pics of a Caterpillar 16M grader axle on our trailer for delivery. All the bores were machined, welded up & bored back to the new spec sizes. New bushings & seals have been installed prior to final assembly with new pins & hardware. All the components of the axle have been rebuilt & [...]
Here’s some pics of a Caterpillar D10T2 hardnose we picked up for repair & rebuilding. This hardnose contains two aluminum radiators, two aluminum aftercoolers (CAC's), an aluminum oil cooler & an aluminum AC condenser in addition to the fan blade & hydraulic fan motor. There's more parts in there as well that make up the [...]
Here's some pics of a Caterpillar 16M Grader Axle we're repairing all the bores on & doing a complete rebuild to. It's been a minute getting all the parts for this one but it's just about ready to go. All the bores have been machined, welded & then bored back to Caterpillar specs with new [...]
Here’s some pics of a Perkins diesel engine we rebuilt out of an Xtreme XR4030 Telehandler. This Perkins engine is based off of the Caterpillar C4.4 engine. The 1204E-E44TTA engine is a Stage IV, or Tier 4, Final Emissions equipped compact diesel engine. In addition to rebuilding the engine itself we also installed all the [...]
Here’s some pics of a delivery we made to some of our mining customers. The radiator is for a 793C Cat haul truck. Behind the radiator is a fuel tank for a 777 Cat. On the back of the trailer is a hydraulic tank for a 793C Cat haul truck. Wrapped up in orange shrink [...]
Here's some pics of the parts of a Caterpillar 16M grader axle we're rebuilding. The ends of the main axle frame are worn where the lean arms are installed. The inner faces are welded up & then the inner faces are machined to provide a tight & solid mounting of the lean arms at each [...]
Here's some before & after pics of a fuel tank for a Godwin pump. The fuel tank also serves as a skid that the engine & pump mount to & sit on. After cleaning the tank of all the gunk & debris from the inside we did a pretty good amount of cutting & welding [...]
Here’s some pics of a Caterpillar 793C Hydraulic Tank we repaired & reconditioned. The tank came in with some bent & tweaked walls & the whole tank was pretty much out of square. We replaced two walls of the tank as well as the manifold blocks that the Hydraulic fittings, lines & pipes connect to. [...]
Here’s some pics of a dual oil cooler & air cooler assembly off of an Epiroc Pit Viper 271 drill rig. The cooling module assembly consists of two oil coolers, an air cooler, two fans, two fan drive motors, fan guards and shrouding to make up a complete drop-in cooling package. We fabricated a stand [...]
