Industrial & Heavy Equipment

Here’s some pics of a Caterpillar 793C rear axle a-frame support during the various stages of the repair process. The large bore at the tip of the a-frame, or wishbone, is the hitch pin bore. When we check these for cracks we often times find cracks in the bore as well as the bolt holes [...]

Here’s some pics of a Caterpillar 16 series grader circle with the drawbar a-frame & moldboard during our rebuilding process. All the pieces & parts were blasted down to raw metal & dye checked for cracks. After all the cracks were identified, prepped & repaired with welding the machine work commenced. All bores were machined [...]

Here’s some pics of a Caterpillar 16G Grader Circle Assembly we are rebuilding. It has been blasted down to raw metal & dye checked for cracks. We will get the cracks cleaned out, prepped & welded up. It has some badly worn teeth so we will get the bad sections cut out & weld new [...]

Here’s some pics of a Caterpillar 16G Grader Circle and Drawbar A-Frame assembly we repaired & did a complete rebuild to. All the component parts were blasted down to raw metal so we could dye check for cracks. Once all the cracks were identified we prepped & welded them up. All the worn bores were [...]

Here’s some pics of a diesel fuel tank off of a Caterpillar D10T dozer that we reconditioned. The tank came in due to some leaks which we found to be coming from some cracks. After thoroughly cleaning the tank inside & out we blasted it down to raw metal. We then had to cut some [...]

Here’s some pics of some heavy equipment parts we picked up for repairing & rebuilding. The three large pieces are all for a Caterpillar 793C haul truck. There's the radiator, a rear axle a-frame support & a fuel tank. On the very back of the trialer is an aluminum oil cooler for an air compressor [...]

Here’s some pics of a new replacement pinion gear for a Caterpillar Grader. The pinion mounts to the splined shaft of the circle drive motor. The part number for this pinion is 558-2101. The 5582101 pinions are normally extremely worn which require replacement every time we get a grader circle in with the drive motor [...]

Here’s some pics of a Caterpillar 793F haul truck fuel tank we did a complete rebuild to. The tank came in due to some leaks from several cracks in the tank. After thoroughly cleaning the tank inside & out it gets blasted to raw metal in order to inspect & detect the cracks. The cracks [...]

Here’s some pics of a Caterpillar D10T hardnose cooling package we rebuilt. We disassembled the entire nosecone assembly down to the bare grill guard housing. The hardnose had some cracks which we prepped & welded. The radiator that mounts inside the nosecone is a Mesabi type which got completely rebuilt & pressure tested. Both aftercoolers [...]