Skip to content
Here's some pics of an LS1 stroker engine we're getting ready for assembly. The engine will end up with 427 cubic inches. The internal parts consist of a steel stroker crank, h-beam connecting rods & Wiseco forged pistons. Everything will be held together with ARP fasteners. Motor Mission Machine & Radiator 5435 Desert Point Dr. [...]
Here's some Caterpillar loader & rubber tire dozer oscillating axle trunnion & pinion supports that we reconditioned. The bores & the mounting pad surfaces were worn & fretted. We machined & bored them to true them up, then welded them to build the surfaces back up. We then bored & machined the welded areas of [...]
This is a Caterpillar 3406E / C15 style cylinder head we did a valve job & surface to. The surface of the head was warped so we mounted it on our Rottler multipurpose CNC milling & boring machine. After we got the surface flat & square the valve recessions needed to be adjusted back to [...]
This is a Mercruiser 4.3 liter Chevy V6 engine we're rebuilding for a marine application. All the machine work was done to the block which included align honing the housing bore, surfacing & squaring the decks of the block & boring & honing the cylinders for new oversize pistons & moly rings. The cylinder heads [...]
This is a set of two stroke cylinder jugs for a Yamaha Banshee. They came in with some scratches & scoring in the bores. We rough bored them to see what size they would clean-up at & then ordered a set of ProX pistons. We then bored & honed both cylinders for the new oversize [...]
This is a Duramax diesel engine out of a Chevy Silverado 3500hd truck. The crankshaft cracked at the number one rod journal & the number two main journal. This caused the number two main housing bore to take a beating. We have the block fitted with billet main caps & a girdle from Wagler Competition [...]
This is a small block Chevy V8 engine we're finishing up the rebuild to. The engine was disassembled, cleaned, checked & measured. We performed all the machine work to the block, crank, connecting rods & cylinder heads along with balancing of the rotating assembly. The engine is currently in the final stages of assembly. Motor [...]
This is a 2007 Chevy 6.6 liter Duramax LBZ diesel engine block getting the housing bore line bored on our Rottler EM105H CNC machine. The block is fitted with a set of Wagler billet main caps held in place with a set of ARP main studs. Motor Mission Machine & Radiator 5435 Desert Point Dr. [...]
This is a 6.6 liter Duramax diesel V8 steel crankshaft. The engine developed a knock that kept getting louder. After the engine was disassembled we found the number two main housing bore is a bit damaged so we suspected the crank was cracked. It didn't break but it's close to it. The crank is cracked [...]
This is a 1998 Chevy 350 small block engine we did all the machine work to. After the block, cylinder heads & connecting rods were thermal cleaned & blasted they were all magnafluxed for cracks. The rods got their big ends reconditioned while the heads received a three angle valve job & surface. The block [...]
