Skip to content
This is a 1945 Hercules model JXLD flathead gasoline engine we're finishing up the machine work on. This engine is getting a complete rebuild restoration. It goes into a 1945 Lorain crane. Motor Mission Machine & Radiator 5435 Desert Point Dr. Las Vegas, Nv. 89118 Ph: (702) 649-2366 or (702) 649-0648 Fax: (702) 649-4133 www.MotorMission.com [...]
This is a Chevy small block engine block that came in for machine work. The engine sat with water in the cylinders long enough for rust & pitting damage to take place. The block is in our Sunnen CK10 cylinder hone getting it's cylinders rough honed to see what size they will clean up at. [...]
This is a set of 304 cubic inch AMC V8 cylinder heads that came in for rebuilding. They are off of a 1980 Jeep Wrangler. One of the exhaust valves was cracked from being burnt. We did a complete rebuild including magnafluxing for cracks, pressure testing for leaks & a three angle valve job & [...]
This is an aluminum Yamaha cylinder head with five valves in the cylinder or combustion chamber. We removed the old valve guides, installed some new valve guides & reemed them to size for the valve stems of the new valves. We then performed a three angle valve job & surface. Motor Mission Machine & Radiator [...]
Here's some random pics of parts we're machining in the machine shop. The vintage Suzuki motorcycle engine got cleaned & surfaced on the decks of the cylinder head as well as the cylinder block. The cylinders also got a bore & hone to some new Wiseco forged pistons. The cylinder head being surfaced is a [...]
This is a set of Chevy GM aluminum LS cylinder heads. We did a complete valve job & surface to both heads. The heads were disassembled, cleaned & inspected before getting the valve seats machined & the decks surfaced & milled flat & square. Motor Mission Machine & Radiator 5435 Desert Point Dr. Las Vegas, [...]
This is a Hercules model JXLD gas flathead engine we're machining. We're doing a complete engine restoration rebuild on this antique engine. It is out of a 1945 Lorain Model TL20 crane that is getting a full rebuild & restoration. Motor Mission Machine & Radiator 5435 Desert Point Dr. Las Vegas, Nv. 89118 Ph: (702) [...]
This is a 3406B Cat cylinder head we did a valve job & surface rebuild to. The thickness of the head varried as much as .006 (six thousandths) before we machined it. We set it up & leveled it on our Dual Axis Leveling Table on the Rottler EM105H & got it within a thou. [...]
Here's a 5.9 b-series Cummins diesel engine block getting its surface milled square & flat on our Rottler EM105H. This block also got the housing bore align honed & the cylinders bored & honed for oversize pistons & rings Motor Mission Machine & Radiator 5435 Desert Point Dr. Las Vegas, Nv. 89118 Ph: (702) 649-2366 [...]
Here's a Cummins M11 diesel cylinder head we're doing a valve job & surface to. The head is mounted on the Rottler EM105H with the Dual Axis Leveling Fixture. After surfacing, the head will get a final wash before it gets assembled. Motor Mission Machine & Radiator 5435 Desert Point Dr. Las Vegas, Nv. 89118 [...]
