Skip to content
This is a cylinder jug & press together crankshaft that came in off of a Kawasaki motorcycle. We will be machining the plated cylinder for a sleeve from LA Sleeve, installing the sleeve, & then boring & honing the cylinder sleeve to the new Wiseco forged piston. The crank will be taken apart & pressed [...]
This is a 5.9 Cummins diesel engine we did all the machine work to. We polished the journals of the crank after wet-magging it for cracks & checking it for straightness. The head got a complete valve job & surface while the block got bored & honed for oversize pistons & the deck surfaces & [...]
Here's some parts we got in for a turbo Suzuki Hayabusa engine we're building for a sandrail. We're shooting for 500 horsepower with this build so this engine is getting the works with a set of forged h-beam connecting rods & forged pistons from Wossner. Motor Mission Machine & Radiator 5435 Desert Point Dr. Las [...]
Here's a 2006 Yamaha 125 dirt bike cylinder head we did a complete valve job & surface to. After disassembling the head we tanked & blasted it clean, removed the valve guides, installed new valve guides, reamed the guides to the valve stems, machined the valve seats, milled the surface flat & square & then [...]
Here's some pics of some random jobs we have in the machine shop. The engine is a 400 SBC (small block Chevy) that we did a complete rebuild to with all roller valve train parts. The aluminum cylinder heads are off of an LS based GM engine & the connecting rods are for a 427 [...]
This is an aluminum snout off of a 6-71 Weiand blower that came in for new bearings. The supercharger was making a clunking & knocking noise due to the bearings going bad in the snout. We pressed the old damaged bearing & seal out & pressed in some new ones. Motor Mission Machine & Radiator [...]
This is an old cast iron water pump off of a Continental engine that is in a Clark forklift. The pump came in for repair & rebuilding. We had to machine a new shaft as well as the housing for the new bearings & seals. We got it rebuilt & back together & ready for [...]
This is a set of cylinder heads, connecting rods & the crankshaft for a 292 Y-Block out of a 1955 Ford Thunderbird. We did a three angle valve job & surface to the heads & reconditioned the big ends of the rods with a set of ARP rod bolts. We then balanced the crank & [...]
This is an older antique water pump & governor that was shipped to us for repairing & rebuilding. It's off of a Cletrac crawler dozer that is being restored for a museum on the east coast. We had to make a new shaft & machine the housing for the new bearings & seals. Motor Mission [...]
This is a 3.8 liter V6 Ford engine we did a short block rebuild to. This particular engine was out of a Mercury Cougar but it is the same engine that was also in the Ford Thunderbird as well as some other Ford models. We performed all the machine work to the block, crank & [...]
