Skip to content
Here's some before & after pics of an Ingersoll Rand DML drill rig radiator & lo-temp aftercooler we reconditioned. The radiator portion is a bolt-on with a conventional flat fin core & six rows of tubes. The LTA, or lo temp aftercooler, is an all aluminum heat exchanger which is constructed with a bar-and-plate core. [...]
Here's some pics of some Wiseco engine parts we ordered for a Kawasaki KX250F engine build. The main parts for the engine build are included in the Garage Buddy Kit which includes a new crankshaft with connecting rod, forged piston with rings, cam/timing chain & a full set of gaskets. In addition to those parts [...]
Here’s some pics of a complete cooling package we picked up for a Caterpillar 793F haul truck. The heart of this cooling module is a Mesabi Radiator which is concealed behind a lot of other cooling system components. On the grill side are two aluminum aftercoolers & an AC condenser mounted down below those. On [...]
Here's some pics of a delivery we made of some heavy equipment parts we repaired & rebuilt. On the front of the trailer is an Ingersoll Rand DML drill rig radiator & LTA (Lo-Temp Aftercooler). On the middle of the trailer is a Caterpillar 793C haul truck rear axle A-Frame support & a 16G Grader [...]
Here’s some pics of a load we picked up from one of the mines way up north. We went to pick-up a 793C Radiator and ended up fortunate to also pick-up a rear axle A-Frame Support & a Fuel Tank. All three parts are for a Caterpillar 793C haul truck. 5435 Desert Point Dr. Las [...]
Here's some pics of some aluminum bar-and-plate hydraulic oil coolers for a Caterpillar 6060FS shovel. The coolers came in for repairing & rebuilding as they were houred out & some small leaks had developed. After getting the coolers all cleaned up & repaired we gave them a rigorous pressure test to ensure they are leak [...]
Here’s some before & after pics of a CanAm SxS cylinder head that came in for machining to the deck surface. The surface of the head was warped & slightly twisted. Once mounted & leveled on our machine it ended up requiring fourteen thousandths of material removal to get the deck surface flat, square & [...]
Here’s some pics of a 1938 LaSalle radiator we recored. The radiator came in for a complete overhaul, or rod & repair. The core unfortunately wasn't up to the task as we discovered several leaks during multiple pressure test & repair attempts. Our customer agreed to proceed with our recommendation of recoring the radiator with [...]
Here’s some pics of an LS engine we did a cam swap to. The engine had a BTR (Brian Tooley Racing) camshaft installed in it which was a little too aggressive for the application. Since this vehicle is a Chevy Tahoe which is an everyday grocery getter we elected to install a much less aggressive [...]
Here’s some pics of a 793F Cat Mesabi Radiator going through our shop during the rebuilding process. The Mesabi Radiator itself is completely rebuilt before the cooling module parts start getting installed. After all the cooling system parts have been installed to complete the cooling module it will be a complete drop-in cooling package. 5435 [...]
