Skip to content
Here's a couple of aluminum radiators for a 2006 Lamborghini that came in to be repaired. Our customer previously had them at another radiator shop but he wasn't satisfied with their work as the radiators both still leaked. Due to the bad work performed by the other shop we couldn't do much to [...]
This is a Ford Lincoln 430 cubic inch V8 engine from the '60's that came in for a rebuild. We completely cleaned, magnafluxed, measured, and inspected the block, crank, connecting rods, & cylinder heads. We then performed all the necessary machine work including the balancing of the rotating assembly before we assembled the [...]
This is a Komatsu WA900 loader radiator with two intercooler charge air coolers attached to it. The complete radiator and coolers assembly came in to be cleaned, overhauled, and repaired. The core of the radiator was leaking as well as the cores of both of the air coolers. Since the cores were all [...]
This is a Komatsu WA1200 loader Mesabi style radiator & oil cooler assembly that we overhauled. The radiator came in to be completely rebuilt and cleaned out. We removed each of the individual Mesabi L&M radiator tubes as well as each of the upper and lower rubber grommet seals on both the low [...]
This is an older copper and brass radiator from a 60's Ford Lincoln that came in for an overhaul, rod and repair, recore. The surge tank was brought in as well. The core of the radiator was only a standard 3-row so the customer elected to have us recore his radiator with a [...]
This is a set of Cummins 8.3 liter diesel connecting rods that came in for reconditioning and resizing along with the replacement of the wrist pin bushings. For all of your machine work and machining needs please give us a call as we are a complete and fully equipped Las Vegas Machine Shop. [...]
This is an old original copper & brass radiator with a continued flat fin core. The radiator is off of a 1939 Cadillac LaSalle which has a flathead V8 engine. Because the flathead V8 engine has two water coolant outlets on the top is why the radiator has two top radiator hose connections. [...]
This is a set of 3.8 liter GM Pontiac 3800 cast iron V6 cylinder heads. We completely rebuilt & reconditioned the heads by performing a three angle valve job and surface to them. The original cylinder heads that were brought into us were both cracked in their combustion chambers so we actually sourced [...]
This is a Caterpillar 336E excavator backhoe trackhoe cooling unit package that we rebuilt. The cooling package consists of the radiator, CAC (charge-air-cooler), and oil cooler. We completely disassembled the complete package and each heat exchanger got individually cleaned, repaired, & pressure tested. With our fully equipped Las Vegas Radiator Shop along with [...]
This is a set of brake rotors we turned. The rotors came in to be machined because they were warped from excessive heat as well as they had deep grooves in them from excessive wear. We mounted them on our brake lathe and machined them nice and smooth. We measured their thicknesses both [...]
