Skip to content
Here's some random pics of a Caterpillar 793F Mesabi Radiator with the Aftercoolers that we rebuilt. Some of these pics show when we picked up the radiator assembly from our customer, then during the rebuilding process & then when we delivered it back to the mine site when we were all done with it. Motor [...]
This is a Caterpillar 793C mining haul truck folded core radiator we rebuilt & delivered to one of our mining customers. This radiator is one of our exchange radiators that we have in our inventory for our exchange program. Motor Mission Machine & Radiator 5435 Desert Point Dr. Las Vegas, Nv. 89118 Ph: (702) 649-2366 [...]
This is a Caterpillar 793C rear axle support, or A-Frame as we call it. We repair these A-Frames by either welding & machining the hitch pin bore or by completely cutting the bore end out & welding a new yoke in place. After we get the hitch pin bore squared away by machining or by [...]
Here's some random radiator jobs we have going on in the shop right now. The gray radiator & intercooler are for a Caterpillar 6060FS shovel. The black radiator is for a P&H 2650cx shovel. The yellow radiator is for a Caterpillar 777G haul truck. They are all in for repairing & reconditioning. Motor Mission Machine [...]
This is a Chevy Cruze cylinder head that we rebuilt with a complete valve job & surface. The engine is a 1.4 liter turbocharged powerplant. The engine overheated which caused the head gasket to embed itself into the surface of the head leaving lots of low spots. After machining the valve seats round & concentric [...]
This is an older Ford radiator that we rebuilt. It's an all metal copper & brass radiator. After we got it all rebuilt & pressure tested we painted the core, bottom tank & side brackets. We left the top tank raw & massaged it a bit to give it some style. Motor Mission Machine & [...]
Here’s some parts we picked up for rebuilding. The radiator is off a Caterpillar 793C haul truck as well as the wishbone piece on the back of the trailer. The wishbone is the rear axle support which we refer to as an a-frame. Underneath the a-frame is a heat exchanger that is plugged internally & [...]
Here's an old cast iron water pump that came in for repairing & rebuilding. These old water pumps come in due to the seals leaking which usually also means the main shaft is pitted & corroded. We typically end up machining a new shaft if the original one is too far gone. Sometimes the original [...]
This is a custom bolt-on, or bolt together, radiator we built for a hay squeeze that got re-powered with an upgraded diesel engine. The radiator features a heavy duty high efficiency flat fin, or continued fin, core. Attached to the radiator is an aluminum aftercooler, or CAC (charge air cooler), to keep the boosted air [...]
Here’s a couple pics of a Chevy LS engine block on our Rottler CNC machine. The cylinders are getting bored for a set of oversize Wiseco forged pistons. Next is surfacing & squaring the decks. Motor Mission Machine & Radiator 5435 Desert Point Dr. Las Vegas, Nv. 89118 Ph: (702) 649-2366 or (702) 649-0648 Fax: [...]
