Skip to content
Here’s a Nissan SR20 cylinder block that came in with a set of ARP main studs. We surfaced the machined flats of the main caps before torquing them down with the ARP studs. We then line bored the housing bore & then finish honed the mains to size. Motor Mission Machine & Radiator 5435 Desert [...]
Here’s some pics of a high performance big block Chevy engine we built. It is 427 cubic inches with just under ten to one compression. It features a custom ground hydraulic roller camshaft from Competition Cams, Comp Cams full roller rockers & Sealed Power forged pistons. The high clamping load areas are torqued in place [...]
This is a hardnose assembly off of a Caterpillar 994K loader that we have in for a complete overhaul. The nosecone houses twenty one aluminum radiator cores, two transmission oil coolers, two aftercoolers, a rear brake cooler, five steering oil coolers & an AC condenser. Twenty thousand pounds of pieces & parts & lots of [...]
This is an air conditioner box unit for a Caterpillar 6060 Shovel we did a complete rebuild to. The air conditioning unit is made by Sigma & most of the parts have to come out of Australia. We replaced the filter drier, the receiver drier, the three electric fan motors & the plastic fan blades. [...]
This is a Caterpillar 793C mining haul truck radiator we're finishing up the repair & overhaul to. These pictures are from partial assembly to complete assembly & the final pressure testing. After the pressure test we'll install all the fan shroud pieces & parts & it'll be ready for delivery to the mine site. Motor [...]
Here's an aluminum radiator for a Cat D10 dozer in our test tank getting pressure tested. We first steam cleaned the external fins clear of all the dirt & debris. We then flushed it internally before giving it a good soaking in the ultrasonic. After repairing the damaged areas we gave it a final pressure [...]
Here’s a Caterpillar 16G Grader Circle with the Blade that we picked up for repair & rebuild. Several of the teeth, or segments, up inside the circle assembly are damaged & worn as well as the pinion gear on the hydraulic circle drive motor. We'll get it all apart, blasted, checked for cracks, repaired & [...]
This is a custom all metal copper brass radiator we built for a genset unit. The original radiator was comprised of an aluminum core with plastic tanks. Both plastic tanks were cracked on the original radiator so we recommended an all metal replacement. The new radiator is made with a heavy duty high efficiency copper [...]
We're on a long weekend & late night getting this one done. This is a Caterpillar D10T2 dozer hardnose nosecone assembly. We completely disassembled the hardnose removing both radiators, both aftercoolers, the hydraulic oil cooler & the AC condenser along with all the hoses, lines, wiring, fan & hydraulic fan motor. After cleaning, repairing & [...]
This is a hydraulic cylinder we rebuilt. It is the dipper cylinder off of a John Deere 410E backhoe. We completely disassembled the cylinder & ram for cleaning & repair. We then reassembled the complete hydraulic cylinder assembly with new seals & then gave it a fresh coat of paint. Motor Mission Machine & Radiator [...]
