Skip to content
Here’s a load we delivered to some of our mining customers. On the front of the trailer is a Caterpillar 16G grader radiator that we completely rebuilt with its folded core sections. On the middle of the trailer is a Caterpillar 793C haul truck A-Frame that we cut the center yoke out of & welded [...]
Here's a Chevy GM LS engine block, crankshaft, connecting rods & Sealed Power forged pistons ready to go. We got lucky with the ARP hardware again!! We set the connecting rods up with a set of ARP rod bolts & reconditioned them accordingly. The main studs were torqued in place & the housing bore was [...]
Here's a load of Caterpillar 793C haul truck parts we picked up. There's a radiator, brake coolers, hydraulic oil cooler & a steering bellcrank or Y-Link. These parts will be added to our stock of rebuilt inventory for service exchange as needed by our customers. First off will be getting it all cleaned up, repaired, [...]
Here’s a pick-up for some quick turnaround jobs. On the front of the trailer is a Caterpillar 793F haul truck Mesabi Radiator with the two copper aftercoolers mounted to it. On the back of the trailer is a D10T2 dozer hardnose, or nosecone, assembly which houses two aluminum radiators, two aluminum aftercoolers, an aluminum hydraulic [...]
This is an aluminum Chevy, or GM, LS1 block we are machining. We fitted the block with a set of ARP main studs for line boring & align honing the housing bore where the main bearings go. After boring the cylinders for new oversize pistons in the boring machine, a torque plate was torqued in [...]
Here’s an aluminum radiator & intercooler we picked up for repair & return. We call it the cooling stack assembly. This is a complete drop-in cooling package which makes swapping out the radiator & intercooler much easier & quicker for the mechanics. Motor Mission Machine & Radiator 5435 Desert Point Dr. Las Vegas, Nv. 89118 [...]
This is a lean arm for the front axle of a grader. The bores as well as the surfaces where the lean arm pivots get extremely worn & damaged. After cleaning & blasting the lean arm we check them for cracks. If they pass inspection for re-use the bores & surfaces are machined, then welded [...]
Here's a plastic aluminum radiator that came in off of a genset, or generator. The plastic tanks are cracked so we quoted our customer for a custom built all metal copper & brass replacement. We spec'd out a high efficiency copper brass core & made the brass tanks along with the mounting tabs & soldered [...]
This is a custom all metal radiator we finished. The inlet & outlet tanks are made of brass while the high efficiency core is made of brass tubes & header plates with copper fins. The brass tanks are soldered to the brass headers of the core. The look of a fresh copper & brass radiator [...]
This is a GM Chevy LS engine block we did some machine work to. We first did a line bore to the mains with ARP main studs & then align honed the housing bore to the finished size. We then bored & torque plate honed the cylinders for some new Wiseco forged pistons. We then [...]
