Industrial & Heavy Equipment

Here’s some pics of a Caterpillar dozer equalizer bar. We get these equalizer bars in mostly off of D10 & D11 dozers. The bores are usually worn out-of-round & require boring them round & true. We then weld the bore(s) after boring them to replace the removed material & then we machine the welded bores [...]

Here’s a few pics of a Caterpillar Grader Drawbar & Circle we're in the process of repairing & rebuilding. The drawbar is getting some cracks prepped for welding. A section of teeth on the Circle are worn & damaged so we have cut the bad ones out. Next will be prepping for & installing new [...]

Here’s some pics of a Caterpillar 793C mining haul truck diesel fuel tank we reconditioned. The tank was blasted down to raw metal so we could identify the cracks & weld them up. The internal baffles that were cracked & broken were repaired & welded as needed. After final cleaning & prepping the tank was [...]

Here’s some pics of a Caterpillar 793C rear axle a-frame support during the various stages of the repair process. The large bore at the tip of the a-frame, or wishbone, is the hitch pin bore. When we check these for cracks we often times find cracks in the bore as well as the bolt holes [...]

Here’s some pics of a Caterpillar 16 series grader circle with the drawbar a-frame & moldboard during our rebuilding process. All the pieces & parts were blasted down to raw metal & dye checked for cracks. After all the cracks were identified, prepped & repaired with welding the machine work commenced. All bores were machined [...]

Here’s some pics of a Caterpillar 16G Grader Circle Assembly we are rebuilding. It has been blasted down to raw metal & dye checked for cracks. We will get the cracks cleaned out, prepped & welded up. It has some badly worn teeth so we will get the bad sections cut out & weld new [...]

Here’s some pics of a Caterpillar 16G Grader Circle and Drawbar A-Frame assembly we repaired & did a complete rebuild to. All the component parts were blasted down to raw metal so we could dye check for cracks. Once all the cracks were identified we prepped & welded them up. All the worn bores were [...]

Here’s some pics of a diesel fuel tank off of a Caterpillar D10T dozer that we reconditioned. The tank came in due to some leaks which we found to be coming from some cracks. After thoroughly cleaning the tank inside & out we blasted it down to raw metal. We then had to cut some [...]

Here’s some pics of some heavy equipment parts we picked up for repairing & rebuilding. The three large pieces are all for a Caterpillar 793C haul truck. There's the radiator, a rear axle a-frame support & a fuel tank. On the very back of the trialer is an aluminum oil cooler for an air compressor [...]