Skip to content
This is a set of 855 Cummins Big Cam III cylinder heads that came in for a valve job and surface. The rocker boxes were also brought in to be cleaned and inspected. The engine was getting coolant into the oil and the crankcase so the mechanic removed the three individual cylinder heads. [...]
This is a set of 1961 Harley Davidson motorcycle aluminum cylinder heads that we performed a 3-angle valve job & surface on. The original old valve guides were worn out and galled so we removed the valve guides and pressed in some new ones. Once the new valve guides were installed we had [...]
This is a rebuilt and remanufactured Ford 5.4 liter SOHC V8 Mod engine that we just sent out. The engine is completely rebuilt with all new internal engine parts. We also supplied our customer with all the external parts needed to make a complete engine R&R and install. These external parts consisted of [...]
This is a cylinder head for a 2001 BMW 330i. The cylinder head is a 3.0 liter DOHC (dual overhead cam) aluminum cylinder head that came in for a valve job and surface. One of the camshafts is extremely worn as well as some of the hydraulic lifter buckets were bad and needed [...]
This is a couple of cast iron V8 engine cylinder blocks we did a bore and hone on. The first two pictures are of a blue 429 - 460 Ford cast iron cylinder block that we bored and honed the cylinders for some new Keith Black KB Hypereutectic pistons. The last two pictures [...]
This is a late model Chevy 350 that has a one piece rear main seal. The block is also set up for a roller cam and lifters so it is referred to as a roller block. The first thing we did was thermal clean the block in our Bayco oven in order to [...]
This is a Hercules White four cylinder diesel engine that came in for a complete engine rebuild. We completely disassembled the engine, thermal cleaned, blasted, magnafluxed, pressure tested, measured, inspected, bored, honed, surfaced, align honed, crank ground & polished, connecting rods reconditioned, cylinder head valve job & surface, & assembled the engine complete [...]
This is a Caterpillar 3406B cylinder head that came in for a clean, magnaflux for cracks, pressure test for leaks and cracks, inspection, valve job, and surface. If you need any machine work, cylinder head rebuilding, engine machining, engine rebuilding, flywheel surfacing, broken bolt removal, aluminum welding, fabricating, rod and repair on your [...]
This is a couple of Cummins ISL-G 8.9 liter inline 6-cylinder cylinder heads we rebuilt and overhauled with a complete valve job & surface. These heads are similar to the 8.3 liter C-Series 12-Valve Cummins diesel cylinder heads but they are actually ran on CNG (Compressed Natural Gas). The ISL-G Cummins is also [...]
This is a set of GM Chevy LS aluminum cylinder heads that we just finished machining. Our customer requested we surface .015 off the surfaces of them in order to raise the compression. We first performed a vacuum test, pressure test and inspection to the cylinder heads. Once we made sure both cylinder [...]
